Page 1 of 1

Launch control

Posted: Sat Jan 09, 2010 1:22 am
by V-Spec race development
By selecting the "always on" and datalog it from the S200 to update, will the launch control work w/o a switch? is it the same as the S300 when you select "always on" Thank you.

Posted: Sun Jan 10, 2010 8:43 pm
by V-Spec race development
Never mind on this one I figured this one out already.
My other question is, how come when I set the launch limiter to 3500rpm and try to rev the motor and the tach showing 4500rpm? why is this. It's 1000rpm off.
My tach is accurate because I tried it on me s300 and set the launch limiter to 3500rpm and it is accurate and shows 3500rpm dead on.

Posted: Mon Jan 11, 2010 11:19 am
by Spunkster
If you datalog, what does it show there?

Posted: Wed Jun 09, 2010 11:30 pm
by Revspeed
V-Spec race development wrote:Never mind on this one I figured this one out already.
My other question is, how come when I set the launch limiter to 3500rpm and try to rev the motor and the tach showing 4500rpm? why is this. It's 1000rpm off.
My tach is accurate because I tried it on me s300 and set the launch limiter to 3500rpm and it is accurate and shows 3500rpm dead on.
i had this problem too after i update the software to 1.1 but mine was like 2500 off
also u should check your a/f after u burn the chip its different from when u tune on ur romulator...........
-somethings up before i updated it was all fine.......................