Not getting any readings!

allan@strd · Post by **allan@strd** » Thu May 31, 2007 12:04 pm

I have gotten Rom Editor 4 and have installed everything in the correct way. I have downloaded the newest version of the Rom Editor 4 which is the 1.0.7.0

When i try to datalog i get no readings at all. Is there something i am missing?

Post by **Spunkster** » Thu May 31, 2007 1:14 pm

Have you burned the eeprom using the Romeditor 4 software? Is the light on the interface box flashign or solid after burning this chip and installing it?

allan@strd · Post by **allan@strd** » Mon Jun 04, 2007 10:54 am

Spunkster wrote:Have you burned the eeprom using the Romeditor 4 software? Is the light on the interface box flashign or solid after burning this chip and installing it?

K i tried burning an eeprom with the new ROMeditor 4, light on the box was solid. Pressed F10 to datalog and still nothing. ..............i also clicked on information to see if it was reading the blue box and this is what i got:

Cable Serial Number: 66
S200 Serial Number: (nothing)
Boost: (nothing)
Datalogging: (nothing)
G Sensor: (nothing)
3 Step: (nothing)

And my S200 that i'm using is fully loaded included G Sensor!!!

Could it be my Romeditor 4 serial cable that's messed up????

Allan

Post by **Spunkster** » Mon Jun 04, 2007 12:16 pm

Has J12 been cut?

allan@strd · Post by **allan@strd** » Tue Jun 05, 2007 12:27 pm

Spunkster wrote:Has J12 been cut?

YESSIR!!!!

Post by **Spunkster** » Wed Jun 06, 2007 10:37 am

Can you describe exactly how you have everything hooked up?

allan@strd · Post by **allan@strd** » Wed Jun 06, 2007 9:38 pm

Spunkster wrote:Can you describe exactly how you have everything hooked up?

ECU > Interface Cable > Blue Box > Datalogging Cable > Rom Editor 4 USB Cable > Laptop