Page 1 of 1

Component Q31

Posted: Fri Sep 19, 2008 1:49 pm
by tsrperformance
On Nitrous/Aux 2, to use A20 (PCS) output to activate a nitrous relay, what needs to be done to Q31? It is a US P75 ECU. Tried it without changing anything on the board but it will not activate the relay.
Thanks in advance

Posted: Fri Sep 19, 2008 3:25 pm
by Spunkster
Nothing should have to be done to the ecu for this to work.

This has been tested and is working in the software as it is supposed to. Without a calibration and datalog showing the problem it is impossible to determine what the problem may be.