Accord CU2 K24Z3 calibration for CT Engineering S/C

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
abar121
Posts: 1
Joined: Fri Jan 10, 2014 4:34 am

Accord CU2 K24Z3 calibration for CT Engineering S/C

Post by abar121 » Fri Jan 10, 2014 4:43 am

Hi,
I am about to purchase the said base kit, including Flashpro, for an international spec CU2 K24Z3 2008 Accord / TSX, ECU 37820-RL6-N51. Is there a map that I can use as a basis to start mapping on the dyno? I am based in Mauritius and facilities / experience with Hondata here is limited / non-existent.

Many thanks,

Alan.

User avatar
Hondata
Site Admin
Posts: 8751
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Accord CU2 K24Z3 calibration for CT Engineering S/C

Post by Hondata » Fri Jan 10, 2014 8:39 am

Sorry, but we don't have any base maps for that ECU. What injectors does the kit use? Setting the injector size & dead time will get you started, but it would need further tuning, especially with regional variations in fuel.
Hondata

Post Reply