Stage 3 cams, k20 build block, IHE

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
jbfd2ar
Posts: 35
Joined: Wed Jun 01, 2011 7:19 am

Stage 3 cams, k20 build block, IHE

Post by jbfd2ar » Fri Feb 14, 2014 12:19 pm

Hi guys, Anybody with similar setup ? Got a tuned map to share ? I am currently tuning my own car. Currently at about 36deg on column 10 on high. I dont dare to up it further. is it safe to go close to 40deg ?

NA
stage 3 cams
k20 12.5:1 compression ratio
Intake
Header
Exhaust

alecsm
Posts: 2
Joined: Tue Apr 08, 2014 5:52 pm

Re: Stage 3 cams, k20 build block, IHE

Post by alecsm » Sat Sep 27, 2014 6:07 pm

Can u help me with your calibration file? Thanks

arraydude
Posts: 31
Joined: Tue Aug 13, 2013 8:25 pm
Location: Argentina

Re: Stage 3 cams, k20 build block, IHE

Post by arraydude » Tue Dec 16, 2014 12:46 pm

jbfd2ar wrote:Hi guys, Anybody with similar setup ? Got a tuned map to share ? I am currently tuning my own car. Currently at about 36deg on column 10 on high. I dont dare to up it further. is it safe to go close to 40deg ?

NA
stage 3 cams
k20 12.5:1 compression ratio
Intake
Header
Exhaust
Which CAMS ?, try max 37degrees and lowering to 30 at high rpm, but you can go to a dynamometer to measure with what make more power...

In realiability terms i dont give more than 37deg

DatLife84
Posts: 22
Joined: Tue Feb 25, 2014 6:18 pm

Re: Stage 3 cams, k20 build block, IHE

Post by DatLife84 » Fri Jul 10, 2015 3:33 pm

Be careful that sounds like a lot of timing with the amount of compression you have. I just have drop in cams and 30 degs. was too much. The least amount of timing close to MBT is your best bet.

Post Reply