AEM SRI Cal Error code P0172

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
originalsaban
Posts: 2
Joined: Fri Jan 31, 2014 10:06 am

AEM SRI Cal Error code P0172

Post by originalsaban » Sun Jul 06, 2014 11:46 am

Hi, i just installed a AEM SRI in my 2007 Civic Si and use the calibration AEM SRI from the list of fpcal, it runs very well but when i turn on the A/C the engine light come on after a short time, when i upload stock calibration it doesnt turn on. Any idea for what can i do? Thanks

User avatar
Hondata
Site Admin
Posts: 8630
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: AEM SRI Cal Error code P0172

Post by Hondata » Sun Jul 06, 2014 11:52 am

The intake is affecting the reading of your AFM (air flow meter) to the degree that it is throwing a code for too rich. Either remove the intake or tune the AFM table to suit the new intake.
Hondata

originalsaban
Posts: 2
Joined: Fri Jan 31, 2014 10:06 am

Re: AEM SRI Cal Error code P0172

Post by originalsaban » Sun Jul 06, 2014 12:32 pm

Thanks, how can i do this?, i want to stay with the intake, my doubt is why is only with this calibration that it show up the error code? With the stock tuned it not show any code.

After turning off a/c the code is gone, when i turn it on the code returns

michaellawrence
Posts: 6
Joined: Sat Jun 07, 2014 9:54 pm

Re: AEM SRI Cal Error code P0172

Post by michaellawrence » Wed Oct 29, 2014 6:27 pm

Hondata wrote:The intake is affecting the reading of your AFM (air flow meter) to the degree that it is throwing a code for too rich. Either remove the intake or tune the AFM table to suit the new intake.
I have this code as well on my 2013 SI with the skunk2 Composite CAI. what do I need to adjust to get my car balanced with the Intake? I know the A/F but.......

Post Reply