ISO Basemap

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
projectFD2
Posts: 1
Joined: Sun Feb 04, 2018 6:50 pm

ISO Basemap

Post by projectFD2 » Sun Feb 04, 2018 7:41 pm

Whats going on guys?

I have an 07 Civic SI Sedan. Swapped to a complete 2008 k24a2 long block.

Installed parts list:
Type R oil pump with new tensioner, chain, and guides. Drag Cartel lower chain guide.

I have a non ported RBC Manifold, I did port match the throttle body to my Hybrid Racing ZDX throttle body spacer.

Zdx throttle body installed.

stock k20z3 injectors

Skunk 2 Racing cold air intake.

Skunk 2 Racing Megapower Header.

Skunk 2 Megapower RR exhaust.

Exedy light weight flywheel.

K20z3 transmission with stage 1 exedy clutch kit.

I have flashpro and am just looking for a proper base map for the time being that wont damage my engine while i wait for my tune. Im new to using flashpro so help would mean alot.

Thanks in advance.

typer86
Posts: 299
Joined: Sun Oct 28, 2012 3:17 pm

Re: ISO Basemap

Post by typer86 » Mon Feb 05, 2018 6:17 am

I can create a base map for you.
But listen - you have an individual Setup so few drive cycles are necessary for sure.

If you're interested /PM me to discuss necessary details to start the process.

sn0rlacks
Posts: 3
Joined: Thu Jul 07, 2016 5:18 pm

Re: ISO Basemap

Post by sn0rlacks » Fri Sep 14, 2018 8:13 am

typer86 wrote:
Mon Feb 05, 2018 6:17 am
I can create a base map for you.
But listen - you have an individual Setup so few drive cycles are necessary for sure.

If you're interested /PM me to discuss necessary details to start the process.
I’m in need of a k25a2 stock base map for my 07 civic si swap any way you can help

Post Reply