K20/K24 8th Gen si basemap help needed!

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
brennan.airey
Posts: 1
Joined: Thu Dec 27, 2018 11:13 am

K20/K24 8th Gen si basemap help needed!

Post by brennan.airey »

Hey all,

Just did the K20z3 top with K24A bottom swap in my 07 civic si. Stock everything currently minus RDX injectors. Obviously the cars running to rich and throwing that code. Got my flashpro today and was hoping for a basemap for this setup! Any help would be appreciated. Need an Etest in a few days and have to get rid of that check engine light ;) I tried to find one in the software but I'm not sure if with this setup i can use one on there.
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: K20/K24 8th Gen si basemap help needed!

Post by Hondata »

Use the 07 Si stock tuned calibration. Reduce the rev limit to suit the K24. Adjust the overall fuel trim until your short term trim is as close to 0% as possible.
Hondata
Post Reply