Hello, I have some doubts about the flashpro in my Civic Si 06+
1) These are my Lambda Adjustment Tables, the area with a value of 12.46 is the area where the car goes into open loop?
With this configuration the car is entering correctly in open loop @ WOT and entering in closed loop @ ParthThrottle?
2) Another question, my car right now is running a Go-Power KSi Cams with Valvetrain Upgrade (Retainers, Dual Valve Springs, etc), this configuration goes crazy the knock sensor, in the 1500rpm-3500rpm range mi car reports aprox. 1800-2400 knocks in a 10 minutes datalog in parth throttle!
This is a ghost knock FlashPro retards ignition, what are the values that would have to put in the Knock Sensor Table to disable Knock Sensor or prevent the ECU detects knock in this rpm range in parth-throttle?
The higher the value, the less sensitive is the knock sensor?
To disable / override the sensor in that range, this table is fine?
3)Last question, my sixth gear was replaced by a shorter gear. This causes in sixth gear the cruise control not works because the ECU detects a speed different from that calculated. No way to fix this?