Target Lambda Tables

FlashPro questions & answers specific to the 2006-2011 Americas Civic Si
Post Reply
web35
Posts: 12
Joined: Sat May 12, 2018 2:29 pm

Target Lambda Tables

Post by web35 » Fri May 31, 2019 6:45 pm

I am trying to use the active tuning feature. It appears that your default/preferred method is to use target Lambda tables for open loop situations however the menu for the Lambda tables specifically references closed loop situations. Can you elaborate on this? Are the target lambda tables in the menu the same for closed or open loop?

web35
Posts: 12
Joined: Sat May 12, 2018 2:29 pm

Re: Target Lambda Tables

Post by web35 » Thu Jun 06, 2019 6:18 pm

I didn't think this question was so difficult.

To simplify: where/how do I view the open loop Target lambda table in Flashpro for Civic Gen 8 SI?
I have searched and looked everywhere I can think of for 6 days now.

Surely someone out there knows the answer to this basic question.

User avatar
Hondata
Site Admin
Posts: 8686
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Target Lambda Tables

Post by Hondata » Mon Jun 10, 2019 4:17 pm

I don't fully understand the question. What do you mean by 'the menu for the Lambda tables'?

"how do I view the open loop Target lambda table"

In the tables window under 'Target Lambda Low' and 'Target Lambda High'?
Hondata

web35
Posts: 12
Joined: Sat May 12, 2018 2:29 pm

Re: Target Lambda Tables

Post by web35 » Sat Jun 15, 2019 1:01 pm

My Tables menu does not have 'Target Lambda' as an option.

Table menu.png
Table menu.png (121.56 KiB) Viewed 555 times

User avatar
Hondata
Site Admin
Posts: 8686
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Target Lambda Tables

Post by Hondata » Mon Jun 17, 2019 7:10 am

Are you using mass flow or speed density?
Hondata

web35
Posts: 12
Joined: Sat May 12, 2018 2:29 pm

Re: Target Lambda Tables

Post by web35 » Mon Jun 17, 2019 8:37 am

Mass Flow

User avatar
Hondata
Site Admin
Posts: 8686
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Target Lambda Tables

Post by Hondata » Thu Jun 20, 2019 8:56 am

Under mass flow you don't get any active tuning options at all. Can you post the calibration you are using?
Hondata

Post Reply