Page 1 of 1

k20z3 into eg6

Posted: Thu May 14, 2009 7:06 pm
by topekoms
is there anyway to use the drive by wire for this swap?
im aware of the throttle body issue and using 02-04 ecu.

so now theres this new flashing thing. am i supposed to get the 02-04 ecu with change it to drive by cable stil? or is there new soliution for me cuz i have the stock ecu but i dont have key so the immobilizer wont work

Posted: Fri May 15, 2009 3:38 am
by Garrett_si
the swap will be easier using RSX 05-06 wiring and RSX 05-06 Kpro + harness

Posted: Fri May 15, 2009 7:14 am
by Hondata
Do not use the 05-06 KPro in an engine swap. Every KPro has an information sheet warning against this. See http://www.hondata.com/techk20transmissions.html

You will need to swap the transmissing case & throttle body. Also be aware that the K20Z3 engine has different mounting locations than the K20Z1 or K20A2.

Posted: Fri May 15, 2009 9:14 am
by Garrett_si
Hondata wrote:Do not use the 05-06 KPro in an engine swap. Every KPro has an information sheet warning against this. See http://www.hondata.com/techk20transmissions.html

You will need to swap the transmissing case & throttle body. Also be aware that the K20Z3 engine has different mounting locations than the K20Z1 or K20A2.


5 of my friend did it :wink:

without VSS problem :twisted:

Posted: Fri May 15, 2009 10:30 am
by Hondata
Perhaps that is why there are so many problems with engine swaps.