Hi HONDATA
I have problem with my AFR IN EURO CTR FN2 after I downloaded FPM 1.1.5.0 FPM. Problem is also in FPM 1.1.5.5
You can see on this grapf my AFR with FPM before 1.1.5.0 and FPM 1.1.5.5
The same map
Uploaded with ImageShack.us
AFR_problem in FN2 with FPM 1.1.5.0 and above!!
I noticed this when I upgraded from 1.1.4.7 to 1.1.5.0 when it was first released. WOT afr was approximately 0.5:1 richer. I have a wideband in my car as well which also read richer. I just adjusted the fuel slightly.
It is safe to run your car like that as it is richer not leaner and the difference is very small.
Nitro if you are worried send me a datalog and I will go over your tune for you again.
I have Marcin's two datalogs with me so I will post them. I was changing lots on my car at this time so 2 of my datalogs will be hard to find.
It is safe to run your car like that as it is richer not leaner and the difference is very small.
Nitro if you are worried send me a datalog and I will go over your tune for you again.
I have Marcin's two datalogs with me so I will post them. I was changing lots on my car at this time so 2 of my datalogs will be hard to find.
- Attachments
-
- 17.04.2010_etunezRev8C-1.fpdl
- (170.57 KiB) Downloaded 385 times
-
- 8C final_31.05.2010.fpdl
- (185.8 KiB) Downloaded 231 times
Spunkster wrote:post actual datalogs showing the difference along with the calibration.
- Attachments
-
- marcin - 8CFinal.fpcal
- (18.82 KiB) Downloaded 240 times
-
- 8C final_31.05.2010.fpdl
- (185.8 KiB) Downloaded 244 times
-
- Rev8CFinal_17.04.2010.fpdl
- (170.57 KiB) Downloaded 366 times