Re: Data logging issues.
Posted: Wed Mar 12, 2014 5:43 am
Nothing error
FP Manager just stop datalogging itself like press the F10 button
FP Manager just stop datalogging itself like press the F10 button
It works fine if use flashpro unit to datalogingDiogo Oliveira wrote:Have you tried to datalog without using the computer, just by pressing the datalog button at FlashPro and then downloading from the unit?
Thanks Bro. U mean car grounding.issues? Not enough or too.many?Diogo Oliveira wrote:Dataloging with FlashPro, without using a notebook, works fine. And you already told you have tried to datalog using another notebook without success.
It could be a grounding issue, take a look at it and see if everything is ok.
If all that is ok, you can wait for the next release to see if it get fixed....I don't have the problem you do, and I'm always performing live tuning and dataloging with my notebook. If nothing works you might have to contact Hondata support and send your FlashPro to be checked by them.It is very important that the ground from the wiring harness to the engine (G101) makes good electrical contact with the cylinder head. Otherwise the return path for the sensors, ignition and VTEC may be through the OBDII connector, FlashPro, laptop, laptop charger and inverter to the vehicle body, which may damage the ECU/FlashPro.
The recommended position for the engine ground is on the stud attached to the cylinder head. While the stock location on the intake manifold will usually work without problems, the stud on the cylinder head provides a better electrical connection. The top bolt holding the radiator water output to the cylinder head is also a good alternative for the ground wire.