Flashpro serial: FP-TSX-US-90238
TSX 07-08 ECU: RBB-A21
FP version: 1.6.3.0
So im driving a 2006 Honda Accord CL7 (not euro R) and swapped a K24a3 + Gearbox. Its running with the Acura TSX ECU.
My Honda dealer did the swap, also they used the 2003-2006 adapter. Everything runs fine, done it with Hondata introduction.
I was dynoing today @ KKS Performance in Germany, they´re professional guys, but they also couldnt help.
We just wanted to upload a basemap from Flashpro (with Windows 8)
Seems like Flashpro didnt see any difference from keyposition.
VIN unlocked, no password
Hope you can help.
ignition on/off, flashpro didnt see a difference
ignition on/off, flashpro didnt see a difference
- Attachments
-
- 20131218_122140.jpg (220.18 KiB) Viewed 3686 times
Re: ignition on/off, flashpro didnt see a difference
First, realize that your setup is unsupported.
Upgrade the software - 1.6.3 is old, 1.7.1 is the current version.
Upgrade the software - 1.6.3 is old, 1.7.1 is the current version.
Hondata
Re: ignition on/off, flashpro didnt see a difference
Sorry wrong picture. Im trying the new version tomorrow.
Here´s the right picture.
Here´s the right picture.
- Attachments
-
- 20131218_151233.jpg (175.05 KiB) Viewed 3677 times
Re: ignition on/off, flashpro didnt see a difference
That message would indicate that the CAN wiring is incorrect.
Hondata
Re: ignition on/off, flashpro didnt see a difference
read this http://www.hondata.com/forum/viewtopic.php?f=37&t=15969, it's not difficult to test with tester if you connected all in corect order.
Known as Vaikis_
Re: ignition on/off, flashpro didnt see a difference
It works, the red CAN from the OBD slides out if im connecting the Flashpro. :)