Throttle body swaps
Re: Throttle body swaps
The RSX/DC5 ECU does not have DBW. It only will work with a cable throttle.
Hondata
Re: Throttle body swaps
Does anyone know anything about the spec of this new GENUINE HONDA J35Y RIDGELINE 78/70MM THROTTLE BODY CIVIC FN2 07-11
Looking to see if the power and resistance requirement are equal to the oe one for Euro fn2 TB
HONDA J35Y Ridgeline Throttle Body. This brand new 2019 Honda throttle body is an excellent upgrade over the FN2 OEM throttle body. It features a 12mm bigger (over OEM) bore - same as the original J37 but cheaper! You will need to port match the RSP and RRC inlet manifold to 70mm otherwise a bottle neck will occur. Complete with plastic T-piece as this throttle body features 1 less vacuum source. The ultimate DBW genuine Honda OEM throttle body. Part number: 16400-5J6-A01
Looking to see if the power and resistance requirement are equal to the oe one for Euro fn2 TB
HONDA J35Y Ridgeline Throttle Body. This brand new 2019 Honda throttle body is an excellent upgrade over the FN2 OEM throttle body. It features a 12mm bigger (over OEM) bore - same as the original J37 but cheaper! You will need to port match the RSP and RRC inlet manifold to 70mm otherwise a bottle neck will occur. Complete with plastic T-piece as this throttle body features 1 less vacuum source. The ultimate DBW genuine Honda OEM throttle body. Part number: 16400-5J6-A01
-
- Posts: 5
- Joined: Sun Mar 25, 2018 6:17 pm
Re: Throttle body swaps
Has anyone tested the K Tuned 72mm drive by wire throttle body? If not, I would like to consider purchasing one, in the name of research. Of course, if we find it suitable for use, I will use it on my TSX CT-E supercharger setup. Any interest???
Re: Throttle body swaps
I was just looking into doing the J35 swap until the tuning shop told me about the problems it can cause. I'm just running N/A anyway.
How about using the motor/controller from the Si throttle body onto a J35 throttle body? If it is a smaller drive motor for the throttle plate then will it still draw too much current driving the few mm larger throttle plate in the J35?
How about using the motor/controller from the Si throttle body onto a J35 throttle body? If it is a smaller drive motor for the throttle plate then will it still draw too much current driving the few mm larger throttle plate in the J35?