FlashProManager v2.4.9 Beta

FlashPro Manager software
User avatar
Hondata
Site Admin
Posts: 8992
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: FlashProManager v2.4.6 Beta

Post by Hondata »

Reflash tachometer progress indicator: This do not work on FN2!
Ok, found that problem and will do a release to fix later today.
Hondata

vtecrasr
Posts: 14
Joined: Tue Jul 19, 2016 6:07 pm

Re: FlashProManager v2.4.6 Beta

Post by vtecrasr »

everything works! thanks again
15 civic si, bolt on's/tuned by cartermotorsports

BEKA-BEKA
Posts: 17
Joined: Sat Apr 09, 2011 10:15 am

Re: FlashProManager v2.4.6 Beta

Post by BEKA-BEKA »

Is it possible to have these ign and fuel adjustment at launch rpm and full throttle options on the R18 2006-2011 and Is there a possibility to have them available in the nearest future? :p

m1ll3rlyt3
Posts: 4
Joined: Mon Aug 01, 2016 7:27 pm

Re: FlashProManager v2.4.6 Beta

Post by m1ll3rlyt3 »

All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.

Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
Last edited by m1ll3rlyt3 on Mon Aug 01, 2016 8:59 pm, edited 1 time in total.
2014 FG4

kenleung8
Posts: 3
Joined: Sun Jul 31, 2016 2:35 pm

Re: FlashProManager v2.4.6 Beta

Post by kenleung8 »

Thanks! Everything works with v2.4.8 for my 2015 Civic Si FB6.

User avatar
Hondata
Site Admin
Posts: 8992
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: FlashProManager v2.4.6 Beta

Post by Hondata »

m1ll3rlyt3: I don't have a crystal ball. You'll have to at least tell me what ECU your vehicle has. Then post the results of the troubleshooting on the previous page, and your calibration.
Hondata

m1ll3rlyt3
Posts: 4
Joined: Mon Aug 01, 2016 7:27 pm

Re: FlashProManager v2.4.6 Beta

Post by m1ll3rlyt3 »

Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
2014 FG4

User avatar
Hondata
Site Admin
Posts: 8992
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: FlashProManager v2.4.6 Beta

Post by Hondata »

Then post the results of the troubleshooting on the previous page
Hondata

User avatar
R-12914
Posts: 354
Joined: Sun Dec 01, 2013 12:13 pm
Location: Germany/Bavaria

Re: FlashProManager v2.4.6 Beta

Post by R-12914 »

R-12914 wrote:In additional to the tachometer-upload indicator if we uploading a map, can you make a feature like this:
https://www.youtube.com/watch?v=jJ465JikHvc

I mean only a fast (faster as in the video) turn up and down the rev counter, the coolant temperature gauge and fuel gauge when the ignition switch on!
Many cars have this feature from factory like a gauge check up!

It would be nice if you could define an option here, where we could enable or disable this feature with a hook in the software!

Is that possible?
Thank you!
Hondata, is this possible on a FN2?
2008 Honda Civic TypeR FN2
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.4.7.0
Firmware: 169

GaryBar
Posts: 3
Joined: Sat Jul 30, 2016 6:25 am

Re: FlashProManager v2.4.6 Beta

Post by GaryBar »

m1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.

Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
is there a value by ur launch disengage speed? Mine was on 0 and it did the same as what urs is doin i then set it to 3mph n boom it worked

User avatar
R-12914
Posts: 354
Joined: Sun Dec 01, 2013 12:13 pm
Location: Germany/Bavaria

Re: FlashProManager v2.4.6 Beta

Post by R-12914 »

Hondata, since the Version 2.4.7.0, the launch control no longer works on my FN2!
Hondata wrote:
Here's a test procedure to follow:
1. Set launch rpm to 3000 rpm. Set full throttle shift to 4000 rpm and 1% throttle. Upload.
...
4. Press the 'cancel' switch and confirm that the tach does nothing. Press in the clutch as well as the 'cancel' switch and confirm the tach shows 3000 rpm.
The set rpms to show with the "cancel" switch still works, but if i rev up the engine, it does not work like before!
Whether clutch depressed or not or cruise main switch on or off!
In any case, the engine revs up over the launch rpm set!

Please can you fix this issue like before?
Thanks!
2008 Honda Civic TypeR FN2
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.4.7.0
Firmware: 169

m1ll3rlyt3
Posts: 4
Joined: Mon Aug 01, 2016 7:27 pm

Re: FlashProManager v2.4.6 Beta

Post by m1ll3rlyt3 »

GaryBar wrote:
m1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.

Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
is there a value by ur launch disengage speed? Mine was on 0 and it did the same as what urs is doin i then set it to 3mph n boom it worked
I'll try that too along with what hondata said with the test procedure
2014 FG4

GaryBar
Posts: 3
Joined: Sat Jul 30, 2016 6:25 am

Re: FlashProManager v2.4.6 Beta

Post by GaryBar »

m1ll3rlyt3 wrote:
GaryBar wrote:
m1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.

Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
is there a value by ur launch disengage speed? Mine was on 0 and it did the same as what urs is doin i then set it to 3mph n boom it worked
I'll try that too along with what hondata said with the test procedure
No probs hope u sorted

vtecrasr
Posts: 14
Joined: Tue Jul 19, 2016 6:07 pm

Re: FlashProManager v2.4.6 Beta

Post by vtecrasr »

m1ll3rlyt3 wrote:All the features work for me except the launch control isn't actually working. I can set it and adjust it but it still revs past where I set it.

Sorry. I have a 2014 fg4 and the cal I'm using is the prl short ram that comes with the software.
make sure you set the disengage speed to 3 mph or whatever above 0mph. I first did that and was like well the cruise buttons work but it would rev past whatever I set the launch at. and then realized I never changed the speed disengage
15 civic si, bolt on's/tuned by cartermotorsports

User avatar
R-12914
Posts: 354
Joined: Sun Dec 01, 2013 12:13 pm
Location: Germany/Bavaria

Re: FlashProManager v2.4.6 Beta

Post by R-12914 »

Hondata wrote:
Reflash tachometer progress indicator: This do not work on FN2!
Ok, found that problem and will do a release to fix later today.
This works fine, now on FN2!
2008 Honda Civic TypeR FN2
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.4.7.0
Firmware: 169

Post Reply