Lambda-overlay highcam in 2.6.5 not working correctly

[typer86]

Hi Hondata,

In latest beta 2.6.4 and 2.6.5 I have identified the following issue:
In 3 gear pull the fuel tables the lambda and lambda-overlay will only displaying in the 50 degrees table although the VTC profil (CAM and CAMCMD) displaying the real CAM angel. (The tables follow cam angle is active/enabled)

Summarize:
The fuel table will follow the VTC cam angle and switch in the correct table but the overlay (lambda values) will be displayed in the wrong table until the end....

Result:
- Hard to tune. :D (no change after adjust the values which are displayed in the overlay)
- Confusing the tuner

See screenshot below

I have this issue on two different systems:
- Surface 4 pro (Windows 10 pro)
- Standard office PC with Windows 10 pro



Thanks for help

issue_1.PNG (115.87 KiB) Viewed 2683 times

issue_2.PNG (131.37 KiB) Viewed 2683 times

issue_3.PNG (128.54 KiB) Viewed 2683 times

[R-12914]

Same issue here on my Dell XPS17 Notebook with Windows 10 Pro, Version 1703!

[Hondata]

What vehicle & ECU is this? That will save me testing all 50 for a start.

[R-12914]

What vehicle & ECU is this? That will save me testing all 50 for a start.

In both cases, vehicle is a "FN2" and ECU part number is "37820-RSP-E03".

I hope this helps?

[Hondata]

Are you remapping the cam angle index? What are the values? Are the indexes different between the low and high speed tables?

You could save a lot of time by following the posting guidelines.

[R-12914]

*File deleted!*

[Hondata]

Ok, the problem is that FlashProManager uses the low cam VTC index table for overlay, and your low and high cam indexes are different. I've changed FlashProManager for the next release.

[R-12914]

Ok, Thanks!

[typer86]

Thank you.