- hondata 1.JPG (130.6 KiB) Viewed 3058 times
Flashpro Manager 3.2.8.0 version box error
Flashpro Manager 3.2.8.0 version box error
Flashpro seems to have a conflict with the current 3.2.8.0 Manager. Tune seems to have loaded correctly.
Re: Flashpro Manager 3.2.8.0 version box error
Are you getting this message after you have uploaded to the ECU using 3.2.8 software?
Re: Flashpro Manager 3.2.8.0 version box error
It happens when I connect the Flashpro to the computer. The Flashpro had the tune loaded on 3.2.8.0. I deleted the tune and reloaded 3 times to the Flashpro and same box appears each time.
Re: Flashpro Manager 3.2.8.0 version box error
But did you actually upload the calibration to the ECU?
Re: Flashpro Manager 3.2.8.0 version box error
Yes. It took 2 tries. First had an engine light emission code. Second try all went well, no errors.
Re: Flashpro Manager 3.2.8.0 version box error
And it is telling you the calibration is still out of date after uploading to the ECU now?
Re: Flashpro Manager 3.2.8.0 version box error
Correct. Each time I connect the Flashpro to the Manager the box appears.
Re: Flashpro Manager 3.2.8.0 version box error
....2018 Hatch MT
I have the same message. It started for me when I updated a few weeks or so with version 3.2.6. I hadn't touched it or reflashed since last summer. I also had an update error that reported with 3.2.6 when I was flashing the ECU... about 1/4 into the flash it said there was an error, then after a min it started reloading again.I think the upload didn't take. The Hondata Mode seemed to be stock tuning. I have no screen shots.
I updated with 3.2.8.0 last night and haven't had a chance to see if the tune is good.
I have the same message. It started for me when I updated a few weeks or so with version 3.2.6. I hadn't touched it or reflashed since last summer. I also had an update error that reported with 3.2.6 when I was flashing the ECU... about 1/4 into the flash it said there was an error, then after a min it started reloading again.I think the upload didn't take. The Hondata Mode seemed to be stock tuning. I have no screen shots.
I updated with 3.2.8.0 last night and haven't had a chance to see if the tune is good.
Re: Flashpro Manager 3.2.8.0 version box error
Well, I think there is a firmware problem. I flashed my original tune and its still not correct. I've attached the tune from July 2018. I think there is a problem with either the traction control or boost by gear. Hope this helps
- Attachments
-
- Jason after 1 month.fpcal
- (9.26 KiB) Downloaded 110 times
Re: Flashpro Manager 3.2.8.0 version box error
The message 'Calibrations stored on the FlashPro are from a previous ...' is normal after an update.
Hondata
Re: Flashpro Manager 3.2.8.0 version box error
Thanks, any thoughts on the update? There was a major downgrade in performance after this update.
Re: Flashpro Manager 3.2.8.0 version box error
I put the factory tune back in and verified the new version is not working correctly. There is no difference in performance.