Hello,
I'm seeing descending knock steps in cylinders 2/4 at WOT beginning at 2600rpm and stepping down until 6k rpm. I'm assuming that this is noise as it is decreasing and not increasing. However, I am hesitant to lower the knock sensitivity in these 2 cylinders. Thoughts?
- I've tried to upload the datalog but it's telling me that it's too large (18,547KB).
2019 CTR - Descending knock steps
Re: 2019 CTR - Descending knock steps
I got it figured out. My apologies for not updating the thread.
Thanks again!
Thanks again!