Cpr misfire and quit running
Cpr misfire and quit running
CPR ran fine for a mile or two then randomly misfired and died. Won't start back up or anything, swapped my buddies unit in, car fired right up and drove it home, put my unit back in and I've got nothing?? Can a cpr unit just quit working like that?
Re: Cpr misfire and quit running
Open it and see if anything is burned inside.
Re: Cpr misfire and quit running
The U4 latch has a slight brown spot on it.
Re: Cpr misfire and quit running
Post a picture please
Re: Cpr misfire and quit running
Check your wiring, especially the COPs. The CPR has got +12V through the coil wiring, reverse polarity or a ground is bad.
Hondata
Re: Cpr misfire and quit running
Wiring is correct, if cop wiring was bad it was out of the box that way, thermostat housing ground is correct, ecu wiring is correct, car has been running fine since January. This was sparatic misfire and then it just quit running.
Re: Cpr misfire and quit running
Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Include a link to this thread.
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Include a link to this thread.
-
- Posts: 1
- Joined: Wed Apr 10, 2024 12:05 pm
Re: Cpr misfire and quit running
I just had this exact same thing happen to me shop checked all the wiring it is correct
Re: Cpr misfire and quit running
Not true, mine failed because the chips were shaved too thin when the mfg tried to de-brand them. Had nothing to do with wiring or placement. It was poor mfg quality