99mm stroke on a rod as thick as my little finger and a cast piston? The difference between 7600 rpm (our recommended rev limit) and 8500 rpm puts more than one extra ton of force on the rod, but the piston probably will break first with a load of 5200 G over TDC.
Oh man ! U really scared me ) I know the math and so on but maybe your finger is a lil bit thicker then you think .. coz guyz r revving 8.5 against your math and so far so good. Revving it all day long isn so good , engine will not last long for shure , but 2-3 times a day to have some fun on a daily driven car its a diff story. Its a honda engine and it must be revved until power climbs , or it will not be a honda. Builded bottoms on forged stuff could be revved to 9k , some guys has such 300whp engines in CL chassis so limiting revs isnt fair poilicy.
Where is 04-06 harness ? I asked for pinout and may ask one more time, and more , and more , and my patience will be rewarded soon , i guess its your favourite slogan, isnt it ?