FLASHPRO Not Detecting VIN Nor ECU

[Dondada03]

I have on 03 UKDM CL9, i have installed a used 07-08 tsx AT ECU, i have also installed my CAN adapter. However, after installing these i decided to test my flashpro to see if the ECU would be detected. The flashpro recognized everything except the ECU. Is this because i have not inserted my VIN into the ECU nor have i had my immobilizer paired with the ECU? or should the flashpro recognize the ECU regardless of this? Please provide me with some feedback as i wish to have this issue rectified.

[Hondata]

It is the CAN wiring. Double check everything.

[Dondada03]

i re pinned the wires, and the ecu was still undetected, however the binary for the ECU was detected where a green tick was displayed. every other subsection under the ecu tab had the I icon. can you provide some further feedback

[Hondata]

What binary was the FlashPro detecting? It might be easier if you send the support information from the help menu.

[Dondada03]

it detected US 07-08 TSX AT ECU

[Hondata]

The flashpro recognized everything except the ECU

it detected US 07-08 TSX AT ECU

Which one? Send the support information please.

[Dondada03]

ive attached the screen shot

[Dondada03]

data from flashpro

[Hondata]

Send the support information please.

[Dondada03]

support information such as? i am not certain of what information ur askng

[Hondata]

From the help menu, with the FlashPro plugged into the vehicle and the ignition on, select 'Send Support Information to Hondata'.

[Dondada03]

i sent the support information about an hour ago

[Hondata]

It is not detecting the ECU. This is either the ECU itself or the CAN wiring.

[Dondada03]

Problem solves ECU is now Detected. One the Wires was not all the way in in the DLC connector.

[Hondata]

Good.