Flashpro not reading VIN/ECU.

FlashPro questions & answers specific to the 2007-2008 US TSX
Post Reply
2.2Lude
Posts: 4
Joined: Sat Nov 05, 2016 2:56 pm

Flashpro not reading VIN/ECU.

Post by 2.2Lude » Sat Nov 05, 2016 2:59 pm

I have a 2006 acura tsx MT. installed the can bus adapter, 2007 acura tsx AT ecu and had it programmed. The ecu starts the car. When I try to lock the flashpro unit to the car it says "VIN not recorded" Under the flashpro tab, all functions are green. The software says ECU not detect or not connected. Flashpro serial number FP-TSX-US-90595, Flashpro manager firmware 2.4.9.0.

Sent flashpro support data a few minutes ago as well.

2.2Lude
Posts: 4
Joined: Sat Nov 05, 2016 2:56 pm

Re: Flashpro not reading VIN/ECU.

Post by 2.2Lude » Sat Nov 05, 2016 4:50 pm

Got it. Seems like the DLC connectors are a bit finicky, when I plugged in the Flashpro to the OBD2 it would push the Red wire back even though it was already "clicked" in place. Not sure what I did to secure it properly but it seems to be working for now.

User avatar
Spunkster
Site Admin
Posts: 17544
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Flashpro not reading VIN/ECU.

Post by Spunkster » Mon Nov 07, 2016 10:44 am

Thanks for the update.

Post Reply