Hondata

I am currently experiencing a small problem with a wide band installation (S200/ P28 ECU). I originally used the narrow band input, which partially works for tuning but of course not for closed loop. I recently contacted hondata regarding the problem and was referred to PLX wideband instructions on the hondata website. I now understand how the Eld input is used to input the 0-5v signal into the ECU. However, How is the voltage calibrated to the specific wide band system using the Romeditor software? I understand that the s300 software allows a switch between ELD and o2 input. Therefore allowing calibration. Any help would be greatly appreciated.

NTK
0-9.00
5-16.00

Jeremy

_________________
Real Performance
Rayne, LA
337 781 5920

Romeditor (s100/s200) does not use the ELD input. Only the s300 can use the ELD input for Wideband readings.

When Romeditor 4 comes out, this should then be available.

If you have a PLX, then you can just input the narrow band signal into the O2 input. You will not be able to datalog wideband readings, but you can see them on your PLX display. This will allow the car to be able to run in closed loop properly.

there it is again, Romeditor 4...



does this also hold for JDM ecu, cus mine seem to work?