OBDI P75 - alternative input to D10

Post Reply
carnot
Posts: 24
Joined: Mon Jun 14, 2010 6:14 pm

OBDI P75 - alternative input to D10

Post by carnot » Wed Feb 07, 2018 11:04 am

I have a OBDI P75 with an s300 v3. I recently ordered the traction control unit and was reading that the D10 input to the ECU is to be used. Currently I am using D10 as my wideband oxygen sensor input. With my P75 can I use one of the other drop down menu options listed under the Traction Control tab (D14, D12, B6) as the input pin? If not which pin can I move my wideband input to so that I can maintain datalogging info for that sensor. Thank you for the help.

User avatar
Spunkster
Site Admin
Posts: 17045
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: OBDI P75 - alternative input to D10

Post by Spunkster » Wed Feb 07, 2018 1:53 pm

You can, but D14 cannot see the full 0-5 volt range, and the other 2 inputs may need modification to the ECU:
http://www.hondata.com/help/smanager/an ... ghtsub=d12
http://www.hondata.com/help/smanager/an ... sub=analog

carnot
Posts: 24
Joined: Mon Jun 14, 2010 6:14 pm

Re: OBDI P75 - alternative input to D10

Post by carnot » Thu Feb 08, 2018 5:49 am

Good information thank you. Just to clarify based on what you shared; simply removing R2 and R3 will enable 0-5v input on B6? Installing the 1N4148 diodes is optional?

User avatar
Spunkster
Site Admin
Posts: 17045
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: OBDI P75 - alternative input to D10

Post by Spunkster » Thu Feb 08, 2018 11:07 am

correct

Post Reply