Hi Hondata
My car is stock 14 SI.
Could you check why my daily driving shift are very jerky.
1 throttle release on gear 1 and 2 suddenly brake the car, I have already tuned slightly injector cutoff with a little help only.
2 injection time when clutch pedal pressed varies refer to unstable Tplate.
My purpose is to have the most daily driving smoothness between shift gears.
Jerky shift daily drive
Jerky shift daily drive
- Attachments
-
- 2017100200.fpdl
- (1.33 MiB) Downloaded 147 times
-
- Read_SI.fpcal
- (20.03 KiB) Downloaded 139 times
-
- Posts: 81
- Joined: Mon Oct 14, 2013 6:14 am
Re: Jerky shift daily drive
Try this. Using VTC tables during overrun should smooth tip-in and I adjusted the overrun MAP pressures to smooth tip-out. You may notice some more rev hang but you can probably put the fuel cut delay lower or back to stock without having much effect on the jerkiness.
- Attachments
-
- Read_SI_edit.fpcal
- (20.04 KiB) Downloaded 151 times
Re: Jerky shift daily drive
Hi Hondata
If I am using vtc table to control decel, do I need to set column 1 and 2/1250RPM up to a proper degree or just leave it with 0 as is.
I will try this map and feedback you. thank you very much.
If I am using vtc table to control decel, do I need to set column 1 and 2/1250RPM up to a proper degree or just leave it with 0 as is.
I will try this map and feedback you. thank you very much.
Re: Jerky shift daily drive
Hi HD
I tested your cal it didnt help. I put cut rpm to 3000 it get more better for low speed go and stop driving.
Do you have any other reminder?
I tested your cal it didnt help. I put cut rpm to 3000 it get more better for low speed go and stop driving.
Do you have any other reminder?