Page 1 of 1

keyspan issues

Posted: Thu Aug 02, 2007 4:23 pm
by fu@k_awd
I have the recomended keyspan serieal usb adapter and am using a dell, my first issue is i have lost they keyspan softwear from the last time (diff lap top) i tried to connect, even then i could not get a connection with any laptop. i ended up bring out the desktop pc and just using the serial cable and it connected fine to unlock 3 step and now i am trying to unlock. use datatlogging. any ideas?

Posted: Thu Aug 02, 2007 4:34 pm
by Spunkster
download the correct driver from

Posted: Thu Aug 02, 2007 10:02 pm
by fu@k_awd
I did that, but i dont have the keyspan assistant i dont think. how am i suppose to set up the keyspan softwear? i went through the install wizard but i didnt get much from that. when i hit connect in hondalogger it never connects.

Posted: Fri Aug 03, 2007 9:27 am
by Spunkster
You must go into the device manager and find out what com port it is using and set Hondalogger accordingly.

Posted: Fri Aug 03, 2007 9:47 am
by fu@k_awd
Were do i go in hondalogger to check/change that?

Posted: Fri Aug 03, 2007 10:03 am
by fu@k_awd
no i have noticed that when i try and hit cnt-m for ecu info the pop up wont come up at all but it will on my home p/c, this is the same problome i had last time.

Posted: Fri Aug 03, 2007 11:39 am
by Spunkster
Hold down the Windows key and press Pause Break on the keyboard. This will bring up the syspem properties. Then click on the Hardware tab and click on Device manager. From there check to see what com port the Keyspan is using.

In Hondalogger you need to go to File, Settings and click on the Recording tab and make sure you select the same com port that the Keyspan is using.