Hondata

Found a other problem.

I use a 4 Bar Hondata MAP Sensor. Set it in the Calibration, Sensors to Hondata 4 Bar.
Wanted to change the Load Index, to match the Sensor.
In the Fuel and ignition Tables i cannot change the Load Index (the dropdown menu is greyed out).
I only can change it in the CAM Angle Tables, but the scaler does not affect any other table.

Software is Flashpro 3.0.9.0
Calibration is Accord-09-Europe-MT

The Accord tables only go to 240 kPa.

Really? I didn't see this information anywhere?

What's the reason for this?

Please let me add one more question: Regardless from that the tables goes not higher than 240kpa, why i'm not able to edit the load index at all?

Sometimes the indexes are shared between multiple tables and cannot be changed with altering all the tables that use the index.