cannot edit Load Index in fuel/Ign. etc. only in CAM
Posted: Sat Feb 23, 2019 5:36 pm
Found a other problem.
I use a 4 Bar Hondata MAP Sensor. Set it in the Calibration, Sensors to Hondata 4 Bar.
Wanted to change the Load Index, to match the Sensor.
In the Fuel and ignition Tables i cannot change the Load Index (the dropdown menu is greyed out).
I only can change it in the CAM Angle Tables, but the scaler does not affect any other table.
Software is Flashpro 3.0.9.0
Calibration is Accord-09-Europe-MT
I use a 4 Bar Hondata MAP Sensor. Set it in the Calibration, Sensors to Hondata 4 Bar.
Wanted to change the Load Index, to match the Sensor.
In the Fuel and ignition Tables i cannot change the Load Index (the dropdown menu is greyed out).
I only can change it in the CAM Angle Tables, but the scaler does not affect any other table.
Software is Flashpro 3.0.9.0
Calibration is Accord-09-Europe-MT