Target Lambda Issue

s300 and SManager software questions & answers
Post Reply
Themyth
Posts: 1
Joined: Sat Aug 17, 2019 7:13 pm

Target Lambda Issue

Post by Themyth » Sat Aug 17, 2019 7:30 pm

Has anyone ran into a issue with their target lambda being highlighted in red? And the percentage +/- value (highlighted in Blue) is a incorrect value during target overlay? The chart use to be separated by 3 different colors. I've changed values in the settings and sensor settings to make all match. Doesn't matter if its in KPA or PSI.
Attachments
Hondata Target Table Values In Red.PNG
Hondata Target Table Values In Red.PNG (171.68 KiB) Viewed 278 times

User avatar
Spunkster
Site Admin
Posts: 17943
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Target Lambda Issue

Post by Spunkster » Mon Aug 19, 2019 9:02 am

Post your calibration please.

TTR
Posts: 37
Joined: Wed Mar 31, 2004 8:48 pm

Re: Target Lambda Issue

Post by TTR » Wed Aug 21, 2019 11:10 am

The values in the table are 87.00, I think you want .87. 87 is much higher than 1.00 which is why they're red. If yo change the values from 87 to .87 the color will change.

Gerry
Posts: 9
Joined: Thu Oct 10, 2019 12:41 pm

Re: Target Lambda Issue

Post by Gerry » Thu Oct 10, 2019 3:28 pm

TTR is correct. Lambda is measured as 1.00 1.01+ or .99-. putting 87.00 is way too high and the program see is and is telling you to correct it. if youre looking for an afr of 12.79 then you need to enter in .87

Post Reply