AEM wide band controller
AEM wide band controller
Can the S300 handle input from the AEM Uego wideband controller? It out puts a 5v signal. According to AEM you run the wideband into the stock O2 signal input wire. I can't find anything in the Help section about setting it up.
The unit I have was boxed on Jul 22 2005. I am assuming this is a later unit. The manual that came with it still list their 0-5 volt output scale. Using the ELD, just diable that input and feed the wideband through that? What do I do about the functionality of the ELD?
Once the ELD is disabled, how do I run the DTCs? Through the Smanager software?
Once the ELD is disabled, how do I run the DTCs? Through the Smanager software?