I've some questions about the setup I used yesterday.
We had an european DC2 ('97) with P72A (USDM), Hondata harness and S300.
No problems about mapping. Only problems with some parameters:
- We can't read knock sensor voltage (always 0.00V)
- We can't go in closed loop without error 41 (O2 sensor heater error)
- There is a strange noise coming out front A/C condensed water purge (with original ECU there isn't) like a little motor always on
Excluding these little problems the car runs very well and we do a great mapping job on the road with a wideband.....a very high step-up in performances.
Issues on DC2 EUDM and S300
Knock will not read until the car is fully warm. Also make sure th knock sensor is enabled. Does the ECU have a separate knock board inside?
Without knowing how you have th e oxygen sensor hooked up it's hard to determine why you have an error, but you can disable the error, or depending on your setup read http://www.hondata.com/techwidebandtuning.html
I have no idea what the noise you are referring to is or could be. Try disconnecting different plugs and see if it goes away.
Without knowing how you have th e oxygen sensor hooked up it's hard to determine why you have an error, but you can disable the error, or depending on your setup read http://www.hondata.com/techwidebandtuning.html
I have no idea what the noise you are referring to is or could be. Try disconnecting different plugs and see if it goes away.
The ECU is a USA P72A with daughter-board inside....took from a GSR Integra.
The knock sensor is enabled but the value in SENSORS window is always 0.00.
About oxygen sensor: I mapped the car with an EXTERNAL LSU4.2; the car is perfecly mapped in open loop; now I reinstalled the original narrowband and enabled closed loop for MAP<780mbar but I obtain a "O2 heater error" - 41; if I go in open loop it doesn't appear; if I disable heater the sensor doesn't work well.
The knock sensor is enabled but the value in SENSORS window is always 0.00.
About oxygen sensor: I mapped the car with an EXTERNAL LSU4.2; the car is perfecly mapped in open loop; now I reinstalled the original narrowband and enabled closed loop for MAP<780mbar but I obtain a "O2 heater error" - 41; if I go in open loop it doesn't appear; if I disable heater the sensor doesn't work well.