can i use my jdm p30 ecu with s300, if only the shape is the problem i can modifie it, cuase this is for a drag use only. i just want to know if the s300 supports jdm p30 board
thanx
S300 & JDM P30
others have made it work, but i think you will lose some functionality so far as generic outputs are concerned.
RaVer Motorsports (559) 733-4711
ravermotorsports@earthlink.net
ravermotorsports@earthlink.net
Yes, we've made it
you can make something like podium with few sockets. It's looks like podium using on S200 with Romulator. You should insert 2 male sockets to the upper level of this podium.
Also you should solder 4-pin socket by wires.
Sure, you could not to close the cover of ECU after this installation, but I think it would not a big problem for drag car )))
Also you should solder 4-pin socket by wires.
Sure, you could not to close the cover of ECU after this installation, but I think it would not a big problem for drag car )))
No dreams, just POWER.