tune for completely fully bolt on 8th gen si

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
sammy
Posts: 4
Joined: Sat Jun 11, 2022 7:11 am

tune for completely fully bolt on 8th gen si

Post by sammy »

3.5in cai skunk2, skunk 2 72mm tb, skunk 2 pro series intake manifold, skunk 2 headers/exhaust and 410 injectors
EFICU
Posts: 3295
Joined: Mon Feb 25, 2019 10:14 pm

Re: tune for completely fully bolt on 8th gen si

Post by EFICU »

Are you running RDX 410's? If so, where were they purchased from?
sammy
Posts: 4
Joined: Sat Jun 11, 2022 7:11 am

Re: tune for completely fully bolt on 8th gen si

Post by sammy »

Yes they are rdxs not sure bought the car all done up
sammy
Posts: 4
Joined: Sat Jun 11, 2022 7:11 am

Re: tune for completely fully bolt on 8th gen si

Post by sammy »

ive tried basemaps on hondata and when i cross over my afr spikes to 15-17 but before its at 11-12 cruising its at 14.5-14.7
EFICU
Posts: 3295
Joined: Mon Feb 25, 2019 10:14 pm

Re: tune for completely fully bolt on 8th gen si

Post by EFICU »

Yeah my concern is the validity of the RDXs. If they are fake it will be impossible to tune it. I can start you on a basemap and see how it looks just to determine the injectors performance. From my recent experience with some fake ones I can probably tell pretty quick. Then we can decide how to tune it from there.
sammy
Posts: 4
Joined: Sat Jun 11, 2022 7:11 am

Re: tune for completely fully bolt on 8th gen si

Post by sammy »

I highly doubt they are fake car made close to 230whp on a setup with a 2.5in semi hot intake, car used to drive perfectly lost the tune and i also just found two of my coil packs had no bolts so i took everything out and cleaned it all. but yes please send a good basemap would be extremely appreciated.
Post Reply