Error Message

silverspoon1996 · Post by **silverspoon1996** » Sat Aug 08, 2009 4:45 am

It keeps giving me an error message when I try to upload a map. It asks me to make sure the most current version is installed. I am running version 1.1.08 BETA. Whats wrong?

Post by **Spunkster** » Mon Aug 10, 2009 10:39 am

Click on Help, and then send informtaion to Hondata. Do this only once and only when instructed by tech support.

silverspoon1996 · Post by **silverspoon1996** » Sun Aug 16, 2009 11:26 am

The upload went, I still sent the information because a new error message came up stating: "This flashpro cannot disable the immobilizer"

silverspoon1996 · Post by **silverspoon1996** » Sun Aug 16, 2009 3:16 pm

Now my car wont start. It came up with the original message while trying to datalog. I sent the information to support.. HELP PLEASE!

silverspoon1996 · Post by **silverspoon1996** » Mon Aug 17, 2009 4:15 am

also I noticed the note on my calibration changed to "DEMENSTRATION CALIBRATION"

It ususally saids "410cc injector start up map"

Post by **Spunkster** » Mon Aug 17, 2009 11:27 am

When you have it in the car and plugged into the laptop and ECU, what at the bottom of the screen has red x's or green checks?

silverspoon1996 · Post by **silverspoon1996** » Mon Aug 17, 2009 2:05 pm

everything had green check marks until i went to datalog and it threw the error message... then all that was green was flashpro. ecu and obd2 were red after that.