could some one help with a basemap for fully built ls/vtec

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
1fsthatch
Posts: 2
Joined: Wed Mar 17, 2010 1:59 pm

could some one help with a basemap for fully built ls/vtec

Post by 1fsthatch »

hey i would like to know if anyone has or could make a basemap for my build the specs are as follows
ls block bored to 81.5mm with wiesco 12.5:1 pistons on eagle rods has a micro polished crank fully blueprinted block with oem coated bearings the head is a type r skunk2 head with skunk2 springs and retainers a full cnc port and polish buddly club stage V cams with a edelbrock victor x intake manifold and skunk2 tb car has a walbro 255 fuel pump with rc injectors that are 370cc has itr headers to a 2.5 inch exhast no cat to a flowmaster
thanks in advance
Post Reply