Hi
I'm runing B16A1 with ITB:s and use only TPS based tables for both low-/highspeed.
Does "Autotune" works if the ECU is in "Open Loop"?
I have an AEM Uego wideband-sensor to monitor A/F and could I use the standard O2 input (D14) or do I need to use one of the other pins (ELD or EGRL)?
Best regards//B.
How to disable Autotune ??
How to disable Autotune ??
Last edited by benci on Fri Jul 16, 2010 1:22 pm, edited 2 times in total.
I did all after the book, but I can't get it working.
Autotune is overcorrecting the A/F and the engine stalls aft a few minutes.
Lamba coversion is set 0V/10AF and 5V/20AF.
The AF readings are the same in the S300 parameters as in my AEM-gauge so that should be ok.
I've tried differnt values (50%, 80%, 10%, 1%) for autotune percent change per cycle.
Turned off the ignition between changes but nothing helps.
So what am I doing wrong???
Plz help!
Autotune is overcorrecting the A/F and the engine stalls aft a few minutes.
Lamba coversion is set 0V/10AF and 5V/20AF.
The AF readings are the same in the S300 parameters as in my AEM-gauge so that should be ok.
I've tried differnt values (50%, 80%, 10%, 1%) for autotune percent change per cycle.
Turned off the ignition between changes but nothing helps.
So what am I doing wrong???
Plz help!