As I mentioned in other topic, I needed a program to recalculate table values from SManager calibrations in case I want to change RPM and/or Load indexes without affecting the calibration behavior.
I searched the net and, for my surprise, I couldn't find one. I asked in this and other forums, and I've got no positive answer, so I decided to make the program myself. There was some work involved, but not more than to recalculate all the affected cell values I wanted to change, and certainly it was a lot more fun.
So, I loaded my current calibration into the program, changed about all indexes the way I wanted, and uploaded the result to my ITR Hondata S300. It appeared to run fine, the calibration behavior is the same, so I guess this program works as I expected.
In case someone is interested, here it is (version 1.1a):S300Calculator.exe
If you don't have the VB6 runtime stuff installed, probably it will not run, so you have to run the setup program:Setup S300Calculator.zip
I find it odd, but apparently no one needed this before, so maybe this program is completly useless to everyone but me. Anyway, I'm still posting it, so if someone tries it and has some trouble, just let me know in this post and I'll try make some sort of instructions manual.
Of course I will not accept any responsibility for any damages that may occur in your PC, vehicle, dog, sister or whatever goes wrong in your life as a result of using this program.