s300 CEL stays on. both green and red LED's stay on
s300 CEL stays on. both green and red LED's stay on
I was replacing the motor in my crx (B20 BLOCK TO LS BLOCK) and thought i was ready to start the car but evidently forgot the ground to chassis since i have the battery relocated in the back. the battery was grounded by the tail lights. and the harness was grounded to the thermostat housing. so who do i send it to or what do i look for burned up?
Re: s300 CEL stays on. both green and red LED's stay on
the car was running fine last week. and i only realized i had a problem when i clicked to acc and smanager was telling me i only had 10 volts
Re: s300 CEL stays on. both green and red LED's stay on
Use a multimeter and check the voltage from the battery to the ECU and find where the voltage is droping. Relocating the battery typically causes more problems than it solves.
Re: s300 CEL stays on. both green and red LED's stay on
I dont believe there is still a voltage issue because i plugged my s300(p72) into a 94 civic 5spd and i still cant get any signal to smanager. turn key to acc and fuel pump primes, CEL stays illuminated. and i still cannot datalog.
Re: s300 CEL stays on. both green and red LED's stay on
What happens when you try to upload to the s300?
Re: s300 CEL stays on. both green and red LED's stay on
Would not let me upload. I pulled my module off and i see where it has a short =/ how much to fix or upgrade to version 3 if its an option still?
Re: s300 CEL stays on. both green and red LED's stay on
Post a picture of what you see.
Re: s300 CEL stays on. both green and red LED's stay on
Heres a pic
- Attachments
-
- IMG_20140407_204530.jpg (732.5 KiB) Viewed 3213 times
Re: s300 CEL stays on. both green and red LED's stay on
Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions (include a link to this thread):
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
instructions (include a link to this thread):
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Re: s300 CEL stays on. both green and red LED's stay on
oops read that to fast. i gotcha. thanks!
Re: s300 CEL stays on. both green and red LED's stay on
"how much to fix or upgrade to version 3 if its an option still?" .. you never contaced me with any options. you simply charged me $250 to replace the board back with a version 1??
Re: s300 CEL stays on. both green and red LED's stay on
replied via email