Before this update my Hondata was working fine - was able to upload my ECU and whatnot. but after I downloaded the new one that just released. It recognized my USB/CAR and said it will update flashpro. It did the update and then my Hondata just died? When I go to device manager it says "usb device descriptor request failed". I tried multiple ports/uninstalling driver and reinstalling and even tried it on a different laptop but get the same problem.
typer86 wrote: ↑Tue May 09, 2017 1:42 pm
Which previous version of the flash pro manager was installed on your PC?
I will wait before update until Hondata drop a comment to this issue....
Hondata wrote: ↑Tue May 09, 2017 2:02 pm
First, what version of windows are you using? The instructions depend on the version because Windows 10 does things quite differently.
Hondata wrote: ↑Tue May 09, 2017 2:02 pm
First, what version of windows are you using? The instructions depend on the version because Windows 10 does things quite differently.
I factory reset my laptop and it worked. But sometimes it can't detect my VIN number, I had to reconnect it 3 times to my vehicle for it to detect. Not sure if that's a bug?
When I installed this new update and uploaded my calibration to my car, it ran really bad and could barely idle. I tried to reinstall the software from your link but it keeps on downloading 2.6.6 but now my firmware has been updated to 2.6.7. I was able to get the car running properly again with the older software but now I am unable to datalog because of the newer firmware.