Fuel Economy
Fuel Economy
With the FlashPro if your fuel economy has decreased, make sure you have FlashProManager 2.6.4 and higher, and uncheck this (under closed loop):
If checked the ECU will switch to WOT (high load operation) sooner, which might give better response but your fuel economy will suffer.Hondata
Re: Fuel Economy
Is it possible at econ mode, this is uncheck?
...And checked when econ is off.
Thanks!
...And checked when econ is off.
Thanks!
Re: Fuel Economy
Hi Hondata team,
Would like to follow up on this one.
Would it be that hard to program say at the following modes (SPORTS / NON-ECO / +R) for the new gen turbo engines, we have an option to enable/disable it.
Simple logic, we what this unchecked when we are out chilling and cruising to save gas. On sporty modes, we need this enabled for better throttle response and faster transition/acceleration.
Thanks!
Would like to follow up on this one.
Would it be that hard to program say at the following modes (SPORTS / NON-ECO / +R) for the new gen turbo engines, we have an option to enable/disable it.
Simple logic, we what this unchecked when we are out chilling and cruising to save gas. On sporty modes, we need this enabled for better throttle response and faster transition/acceleration.
Thanks!
Re: Fuel Economy
Details on this can be found in the help file: https://www.hondata.com/help/flashpro/h ... ghtsub=eco
Re: Fuel Economy
Hi,
Thanks for the link, BUT;
Im specifically asking if "use AFM to determine WOT" will be virtually, by default in the program, checked or unchecked in ECO mode ON or OFF, vice versa.
Thanks for the link, BUT;
Im specifically asking if "use AFM to determine WOT" will be virtually, by default in the program, checked or unchecked in ECO mode ON or OFF, vice versa.
Re: Fuel Economy
That parameter is not tied to ECO mode at all.
-
- Posts: 24
- Joined: Fri Feb 22, 2019 5:02 am
Re: Fuel Economy
I don't see any difference
-
- Posts: 12
- Joined: Tue Apr 10, 2018 6:33 pm
Re: Fuel Economy
we have to Select Determinate by wot or don´t select the icon
Re: Fuel Economy
what if we check use map to determine wot and rewrite on wot table over 12.5? is it work?
Because if not check it car stays 2 second on 14.7 afr at full throttle then wot table works.
So my solution is check it use map to determine wot and rewrite wot table.
Because if not check it car stays 2 second on 14.7 afr at full throttle then wot table works.
So my solution is check it use map to determine wot and rewrite wot table.
Re: Fuel Economy
I have a new solution for fuel economy.
should thick to use map to determine wot and rewrite on wot table.
My table is
1-2-3 coloums have 14.7
4 13.7
5 12.7
7-8-9-10 11.7
With this table i figure it out good fuel economy.
should thick to use map to determine wot and rewrite on wot table.
My table is
1-2-3 coloums have 14.7
4 13.7
5 12.7
7-8-9-10 11.7
With this table i figure it out good fuel economy.