Hey guys I have a s200 with a slowly blinking led but I have no cel on. The cel will come on a few seconds but goes off as it should. I've checked for bad connections but found none. This is a brand new s200 I've bought from someone still in the original box and plastic.
My ecu is a usdm p72 which has already been socketed and chipped running fine before I got the s200. So I got the s200 and hooked up to 4pin cn2, j12 cut, j1 jumped.
The chipped I got it from I had it tuned from phearable.net, could the chip b the problem? It's not a blank chip cause I've been driving on it for a year.
Any help apreciated
Hondata s200 led flashing slowly but no cel on
Hondata s200 led flashing slowly but no cel on
- Attachments
-
- Pic of my p72
- image.jpg (3.32 MiB) Viewed 12234 times
-
- I did not have to solder nothing cause everything is already in place for me to just connect the s200.
- image.jpg (1.65 MiB) Viewed 12234 times
-
- The only wire I did not connect I think it's the clutch switch wire? I don't plan on using it.
- image.jpg (1.64 MiB) Viewed 12234 times
-
- image.jpg (1.66 MiB) Viewed 12234 times
-
- image.jpg (1.56 MiB) Viewed 12234 times
Re: Hondata s200 led flashing slowly but no cel on
You need to make sure that the chip you are using was burned with a Hondata program or it will not work with the s200.
Re: Hondata s200 led flashing slowly but no cel on
Can I do that myself with a chip programmer or how do I go about that?
Thanks for the reply
Thanks for the reply