I did datalog with both plugged in and I posted the datalog. Of course since the TC is new to me I could have done something wrong. I have the CSV file that the TC outputs.Hondata wrote:Can you datalog from SManager with both the S300 and TC plugged in? That way we can see the wheel speeds etc in the SManager datalog.
The datalogged ELD does not look correct. The next step would be to use the TC Testing tab and set a test output voltage, and then check that the ECU ELD is the same voltage.
I have used the test output from the TC module while watching the sensor tab in Hondata. ELD voltage does not change. With key on but car not running ELD voltage starts out at 0 climbs to 1.72v and stays steady. No matter what voltage I use for TC test output. I also verified that the voltage coming from the TC is correct. I cut some insulation from the wire and tested it while it was still hooked up to Hondata. I got the values I posted previously but for each value (0-5v) Hondata ELD value was 1.72v.
Don't know if it helps but here is the TC datalog screen capture I grabbed: