Knock Level
Re: Knock Level
Is there a problem?
Re: Knock Level
There is a considerable knock retard cylinder 2 and cylinder 3 at 18° and cylinder 1 and 4 at 4°
Well, i just need help to evaluate the datalog amd the calibration what causes the knock retard.
Thanks
Well, i just need help to evaluate the datalog amd the calibration what causes the knock retard.
Thanks
Re: Knock Level
Are these knock retards ok or are these so much?
- Attachments
-
- 91.7 throttle improv.fpcal
- (15.05 KiB) Downloaded 145 times
-
- 91.7 octanos con torco.fpdl
- (822.45 KiB) Downloaded 140 times
-
- Posts: 66
- Joined: Tue Jan 26, 2010 7:09 pm
Re: Knock Level
Was checking up to see how my tune was holding up with the recent colder weather and have found that I seem to be getting consistently more knock as well as the fuel pump running at a higher duty cycle.
Previously the fuel pump would peak at around 95% at peak boost, now even after reducing the max air charge I still seem to flirt with 100%.
I'm assuming since its colder the air is more dense and it is adding more fuel to compensate, but for equivalent air charge values it uses more fuel.
Is it possibly a sensor issue or is this normal behavior?
Additionally is it normal for these cars to have a strong smell of gas in the oil?
I know Honda has had issues with oil dilution in their turbo civic and crv models, but I haven't seen any reports of issues with these engines yet.
Also on a different topic I am running a duplicated ECU, if I were to take the car in for services should I flash the ECU with a stock tune or reinstall the original ECU? Would installing the original ECU throw a red flag for them?
Previously the fuel pump would peak at around 95% at peak boost, now even after reducing the max air charge I still seem to flirt with 100%.
I'm assuming since its colder the air is more dense and it is adding more fuel to compensate, but for equivalent air charge values it uses more fuel.
Is it possibly a sensor issue or is this normal behavior?
Additionally is it normal for these cars to have a strong smell of gas in the oil?
I know Honda has had issues with oil dilution in their turbo civic and crv models, but I haven't seen any reports of issues with these engines yet.
Also on a different topic I am running a duplicated ECU, if I were to take the car in for services should I flash the ECU with a stock tune or reinstall the original ECU? Would installing the original ECU throw a red flag for them?
- Attachments
-
- FK8-93oct_ImpThr_Pump_R2nd(3.01).fpcal
- (16.97 KiB) Downloaded 133 times
-
- 93 Octane - Drive Work 1-18-19.fpdl
- (970.26 KiB) Downloaded 152 times
Re: Knock Level
Desperate for help at this point!!!
I have a 2015 9th gen with a stock k24. Skunk 2 CAI and rear hasport motor mount.
I am getting knocks from 5500-6000rpm mostly from 3rd gear and above.
I have had this issue since last year when going through with an etune and have then had the car dyno tuned and i am still experiencing the same issue.
Including the current tune and a log from a good day where the knock was not as heavy
I have a 2015 9th gen with a stock k24. Skunk 2 CAI and rear hasport motor mount.
I am getting knocks from 5500-6000rpm mostly from 3rd gear and above.
I have had this issue since last year when going through with an etune and have then had the car dyno tuned and i am still experiencing the same issue.
Including the current tune and a log from a good day where the knock was not as heavy
- Attachments
-
- stevena_knocklog2.fpdl
- (51.31 KiB) Downloaded 69 times
-
- steven andrews 9th gen (2).fpcal
- (17.45 KiB) Downloaded 66 times
Re: Knock Level
If you want to start your own thread in the 9th gen FlashPro forum I can try to help you with it. This isn't the right thread for your car.9g_steve wrote: ↑Fri Oct 01, 2021 9:55 am Desperate for help at this point!!!
I have a 2015 9th gen with a stock k24. Skunk 2 CAI and rear hasport motor mount.
I am getting knocks from 5500-6000rpm mostly from 3rd gear and above.
I have had this issue since last year when going through with an etune and have then had the car dyno tuned and i am still experiencing the same issue.
Including the current tune and a log from a good day where the knock was not as heavy
From what I see, the knock is all happening in one area. We can try to pull some timing in that area and have you retest. I'm also curious why they have your tune so rich, but we can discuss that in your thread once you make it. Post a thread in here viewforum.php?f=44 , which you can just copy and paste this post in your new thread.
Re: Knock Level
thank you for the reply just posted. sorry new to forums
viewtopic.php?f=44&t=24827
viewtopic.php?f=44&t=24827
Re: Knock Level
I'm new to tune the FK8.
Could anyone help me to see the knocking level 180% of this FK8 is ok?
I see the Knocking level of 180% with no Knocking Retard.
any advice and suggestions will be greatly appreciated
Could anyone help me to see the knocking level 180% of this FK8 is ok?
I see the Knocking level of 180% with no Knocking Retard.
any advice and suggestions will be greatly appreciated
- Attachments
-
- RoadTest.png (116.71 KiB) Viewed 1037 times
-
- RoadTest2.fpdl
- (243.29 KiB) Downloaded 47 times
-
- FK8-1208-20220407ok.fpcal
- (19.55 KiB) Downloaded 49 times