Hello,
I have been using flashpro successfully for a few weeks. Then I removed my engine and now flashpro can't see the ECU. I can't flash my ecu back to stock to unlock the flashpro either. I tried updating flashpro manager and the sub drivers with no luck. It worked fine before I removed the Engine...please help. It did recognize that my battery was getting low so I recharged the car battery and it is still not working.
Flashpro won't recognize my ECU after engine removal
Re: Flashpro won't recognize my ECU after engine removal
You will have to connect the grounds in the engine bay for it to see the ECU.
Re: Flashpro won't recognize my ECU after engine removal
I'll give it a try, thank you!
Re: Flashpro won't recognize my ECU after engine removal
They must be grounded at the battery
Re: Flashpro won't recognize my ECU after engine removal
Turns out it was my fuel pump relay. Interesting...