Anybody do a vtec killer build

FlashPro questions & answers specific to the 2007-2008 US TSX
Post Reply
Rowzswagga
Posts: 13
Joined: Fri Nov 20, 2020 8:25 pm

Anybody do a vtec killer build

Post by Rowzswagga »

So i did the vtec killer build and my car cant idle. I have a good base map and still no chance of idling. Does anybody have a similar setup with flashpro? If not i hope someone has a dual krpo harness for sale that they made years ago.
Camtron
Posts: 3
Joined: Thu Oct 07, 2021 10:20 pm

Re: Anybody do a vtec killer build

Post by Camtron »

I'm also looking for some help on this for my setup. I'm getting way too much fuel and just flooding out my idle.
Rowzswagga
Posts: 13
Joined: Fri Nov 20, 2020 8:25 pm

Re: Anybody do a vtec killer build

Post by Rowzswagga »

Don't do it unless you go standalone. Im still trying to figure out a way to adjust my throttle plate so its slighty open on start up so my car can idle. Right now i created a vacuum leak and now my car idles fine. Im running stage 3 dc cams and it takes a lot of vacuum because of the high lift cams. So the motor will not be able to idle because it has low vacuum pressure. You're better off building the k24a2 head so u run into less problems
yitndaox
Posts: 3
Joined: Wed Nov 15, 2023 2:22 am

Re: Anybody do a vtec killer build

Post by yitndaox »

We're making two comparable motors with two slight changes. Instead of a single rocker, use a two-lobe vtec killer. They are also high compression, ported heads that flow about 370 cfm when using k10 8620.
coreball
Post Reply