Page 1 of 1

Need basemap so i can drive to dyno

Posted: Wed Jun 29, 2022 5:21 pm
by Rambo
I currently have a full race exhaust
Hybrid racing intake
And skunk2 header
Also have a thermal throttle body gasket not sure if im going to install that one
My elevation is about 550’
Thx in advance

Re: Need basemap so i can drive to dyno

Posted: Wed Jun 29, 2022 10:18 pm
by Rambo
Forgot to mention its a 2008 fg2 with almost 190k miles

Re: Need basemap so i can drive to dyno

Posted: Wed Jun 29, 2022 10:34 pm
by Rambo
I also have hasport rear mount installed

Re: Need basemap so i can drive to dyno

Posted: Thu Jun 30, 2022 7:24 pm
by Jvasqu28
I’m assuming you have hondata and there is a basemap on there you could flash, that is for intake/ exhaust/header. That map should be fine for you to drive on. Honestly You'll probably be fine to drive to the dyno with the stock tune. Either way you should be ok since it’s just to the dyno.

Some people go full bolt on without a tune even though it’s counterintuitive to do so. A tune helps maximize performance gains and fine tune drivability/AFR’s.