kpro no sensor reading

K-Series Programmable ECU installation questions / support issues
Post Reply
fourribs
Posts: 3
Joined: Wed Oct 30, 2019 2:13 am

kpro no sensor reading

Post by fourribs »

My Kpro does not show any sensor data or error codes. with key on ignition off. the fuel pump primes OK. I am able to upload and download calibrations. Battery is 12.4V

When I plug the USB in, green LED lights up and stays on, red LED blink once, then flashes, but very dimly, hard to notice unless up close
Car: 2002 Honda Stream auto to manual conversion
engine: DC5 type r
ECU: Kpro4 37820-PNF-A03, S/N 58396 purchased from HAmotorsports July 2021.
Kmanager V4.5.5
Mods: AEM 30-0300 to Kpro Analog 0
screenshot 2023-03-25 135937.jpg
screenshot 2023-03-25 135937.jpg (302.5 KiB) Viewed 372 times
fourribs
Posts: 3
Joined: Wed Oct 30, 2019 2:13 am

Re: kpro no sensor reading

Post by fourribs »

Sorry guys, problem solved. Realized all i had to do was turn on datalogging. feel very stupid about posting this.
please ignore this post, or moderator can delet this
Post Reply