Search found 327 matches

by typer86
Fri Jul 03, 2020 3:19 am
Forum: Civic Type R 2007-2011 European FN2
Topic: ignition timing dip
Replies: 3
Views: 68

Re: ignition timing dip

It seems to me the knock control will do fancy things. Keep a try to set knock igntion limit "low" to 60 on all cam angles and set ignition IAT retard applied to ignition advance. Do also this for highcam... Then tune your igntion profile until the knocks are zero if something will be tracked. Hope ...
by typer86
Wed Jul 01, 2020 11:19 pm
Forum: Civic Type R 2007-2011 European FN2
Topic: need help k count hight
Replies: 17
Views: 255

Re: need help k count hight

Your tune or lambda sensor is the cause of the issue. On WOT you have a extrem lean fuel mixture (you have labmda 0.96) and the target is: 0.86 as best! Go back to your tuner to get the fuel mixture fixed. I think the AFM flow is bad or AFM.c calibration was not set correctly... This is one cause wh...
by typer86
Mon Jun 15, 2020 1:53 am
Forum: K-Pro / KManager
Topic: AEM 30-0300 Wideband Integration with Kpro v4
Replies: 19
Views: 617

Re: AEM 30-0300 Wideband Integration with Kpro v4

KManager configured to show AFR readings.
Wideband_Voltage_5.png
Wideband_Voltage_5.png (117.41 KiB) Viewed 71 times
Attached you find the start calibration and datalog for this.
LPtune_EP3_v1.02.kal
(163.47 KiB) Downloaded 6 times
datalog LP Ep3v1.02_short.kdl
(4.39 MiB) Downloaded 6 times
by typer86
Mon Jun 15, 2020 1:43 am
Forum: K-Pro / KManager
Topic: AEM 30-0300 Wideband Integration with Kpro v4
Replies: 19
Views: 617

Re: AEM 30-0300 Wideband Integration with Kpro v4

Hi, I have also the AEM 30-0300 wideband on the Kpro v4. But I see on the lambda overly the voltage in the KManager 4.4.3.... Did I have something configured wrong? It will not converted into the AF or lambda readings... :-( Kpro <> Analog_Gauge wiring Wideband_Voltage_kpro_wire.jpg KManager configu...
by typer86
Wed Apr 22, 2020 1:22 am
Forum: Civic Type R 2007-2011 European FN2
Topic: General question K20 - popping/crackle noise for a "sport mode" possible?
Replies: 23
Views: 15867

Re: General question K20 - popping/crackle noise for a "sport mode" possible?

Someone have figured out the configuration for Anti-Lag on the FN2? Is this only active on starting if the car is pulling from the start? Or is this feature always active after 3800rpm for example...? An additonal flag for fuel cut delay if this option is active will help to avoid worn the piston ri...
by typer86
Wed Apr 22, 2020 1:08 am
Forum: K-Pro / KManager
Topic: Air fuel mixture always show lambda 1 at WOT
Replies: 4
Views: 294

Re: Air fuel mixture always show lambda 1 at WOT

Thanks for information. The customer will add the AEM wideband ... :) Then we will continue.
Something new learned.
by typer86
Fri Apr 17, 2020 1:50 pm
Forum: K-Pro / KManager
Topic: Air fuel mixture always show lambda 1 at WOT
Replies: 4
Views: 294

Re: Air fuel mixture always show lambda 1 at WOT

So it is normal that at WOT AF 14.7 (lambda 1) will be dispalyed?

I guess the narrow band is also be able to show AF 12.5 (lambda 0.85) - or not?
by typer86
Thu Apr 16, 2020 10:48 pm
Forum: K-Pro / KManager
Topic: Air fuel mixture always show lambda 1 at WOT
Replies: 4
Views: 294

Air fuel mixture always show lambda 1 at WOT

Hi Hondata team, I am tuning currently an EP3 (europe) with KPro4. In datalog I found, that the lambda shows always Lambda 1 (14.7) so I am currently unable to configure the fuel mixture.... The Voltage of the O2 stay on 0.90V also if I add fuel on the table. This car has fitted as primary O2 sensor...
by typer86
Sun Mar 22, 2020 12:41 pm
Forum: Civic Type R 2007-2011 European FN2
Topic: Angle VTC fn2 turbo?
Replies: 4
Views: 896

Re: Angle VTC fn2 turbo?

Yes, you must measure the best VTC cam angel on dyno or with virtual dyno via logs...
by typer86
Tue Mar 17, 2020 3:06 pm
Forum: Accord 2008+ FlashPro
Topic: Accord Cu2 jrsc supercharger knock problem
Replies: 4
Views: 1725

Re: Accord Cu2 jrsc supercharger knock problem

Hi,
Its not tuned very good... I recommend a new tune.
The fuel mixture is to lean on the boost section so it seems to me the main cause of the knocks...

BR
by typer86
Tue Mar 17, 2020 2:45 pm
Forum: Accord 2008+ FlashPro
Topic: Accord Cu2 jrsc supercharger knock problem
Replies: 4
Views: 1725

Re: Accord Cu2 jrsc supercharger knock problem

I will check it and give you feedback later...
by typer86
Tue Dec 17, 2019 10:17 am
Forum: Civic Type R 2007-2011 European FN2
Topic: K20Z4 Base Map
Replies: 2
Views: 1269

Re: K20Z4 Base Map

Iam not sure if kpro working with the RSP based ECU.
If you are using the K20a ECU check the wires and sensors, groundings etc.
Br
by typer86
Mon Dec 09, 2019 1:55 am
Forum: Hondata News
Topic: Soliciting business
Replies: 2
Views: 5594

Re: Soliciting business

Hi,
I can create basemaps for public users here. But not for free - I need 1 - 2h for creation.
by typer86
Thu Dec 05, 2019 12:04 am
Forum: Civic Type R 2007-2011 European FN2
Topic: AFR WOT running issues
Replies: 2
Views: 737

Re: AFR WOT running issues

I have tuned a lot of TTS kits - please contact me if you are interested on a e-tune. (its not free of charge)
by typer86
Wed Dec 04, 2019 4:05 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Supercharged - vtec window pressure
Replies: 5
Views: 630

Re: Supercharged - vtec window pressure

Supercharged versions:
in higher rpm you have more boost - so set a higher switch point. Otherwise you will have jerks if the highcam switch back to lowcam caused by super low map switch points...

For example:
2k rpm = 1.1bar MAP
3k rpm = 1.1bar MAP
5k rpm = 1.3bar MAP
8k rpm = 1.4bar MAP