Hondata

I will do as soon as I take the car out on track again, thanks. How do I send you info?

I have a TC installed on my KPro 3. It works fine as TC but the problem is caused when it kicks in when it should not be. Randomly when accelerating it may kick in for a second and then let the engine rev. It even happened at idle. when I turn the TC off problem solved. i believe its a setup issue. ...

Now installing the speed sensors (Hall effect by race technology). Just a clarification please. The newer type that have the wiring preintalled has already got a resistor built in (the signal wire sends 9.7V signal when supplied with 12V- since they will be powered by the ECU power). So do I just co...

Hi, Just installed the latest Kmanager but does not include Traction Control either under the window or the parameters tab. How can I find it? Pls note that pc not connected to traction control module yet. So with Kpro do we connect the pc with the ECU or the traction control module to adjust the se...

Back again. To start install.

Is the ELD input pin 15 as shown below? So you just need to connect the orange wire to that pin?

Ok, no problem. I am not expecting to have it installed before September so be patient pls.

Yes S1 elise, I will proceed with the installation of the race technology sensors and keep you informed on my progress.

Ok understood. The car is a K20A honda powered Lotus elise. Weight is 750kg and power over 240 bhp, so traction is an issue. The car never had ABS fitted so the easiest thing to do is custom manufacture wheel rings similar to the one shown on the image below: http://www.alpharacing.com/uploads/pics/...

I Have a race car with no ABS sensors installed. Can you help me pls. By reading the instruction it seems that a 2 wire inductive sensor is appropriate. Am I correct? Do you just connect the 2 wires from each wheel sensor to the traction control module without supplying voltage? Where we could buy t...